Welcome to HardwareForumz.com!
FAQFAQ   SearchSearch      ProfileProfile    Private MessagesPrivate Messages   Log in/Register/PasswordLog in/Register/Password

CAT-5 cable stuck in ethernet port - can't remove

 
   Hardware Problem Solving Community! (Home) -> PC Networking RSS
Related Topics:
Linksys Router Port Speed stuck at 10mb - Hello I've got a Linksys Router with a port that will only support 10mb [half or full dpx] My so far 1 - Tried hooking different computers to bad port 2 - 30 sec reset 3 - Full reset i.e. push reset button for 30 sec on > the 30 sec off > ..

Dual Port ethernet NIC Available? - I have two NICs in my PC. One is connected to my DSL modem. The other is via a crossover ethernet cable, to a PC in another room of my home. I would like to free up a slot in my PC by a NIC with dual ports. Problem is, I don't..

Wireless DSL connection for RJ45 ethernet port - Hi folks, Would anyone know how I could connect my desktop PC's ethernet card which has an RJ45 to a wireless broadband DSL network? At the moment my PC is upstairs yet my phone is and I want to get rid of that cable..

12-24 port *silent* 10/100 ethernet switch to replace cisc.. - I have a Cisco Catalyst 2900 XL 24 port 10/100 switch that I'd like to replace with something that runs silent Can anyone reccomend a switch that would perform equally or better than than what I already have that would also run silently? I can..

FA - Linksys 8 port Cable/DSL Router (ebay) - -- Jim H
Author Message
patiwatp

External


Since: Apr 26, 2006
Posts: 1



(Msg. 1) Posted: Wed Apr 26, 2006 2:41 am
Post subject: CAT-5 cable stuck in ethernet port - can't remove
Archived from groups: comp>sys>ibm>pc>hardware>networking, others (more info?)

I just bought a brand-new laptop (Thinpad R52) and connected a CAT-5
cable into the Ethernet port. It seemed a bit tight at first when
inserting the cable, but after a bit of pressure, I felt the cable snap
in to place. Everything worked fine until I tried to remove the cable.
Pressing down on the clip of the RJ45 connector results in a very
quiet snapping sound, but the cable is still stuck hard in place.

I've tried multiple angles, nudging it in deeper and then trying to
remove it, pressing down both soft and hard on the clip, but the cable
is still stuck in the port. This problem is pretty frustrating - in
years of using networking gear I've never seen a cable stuck like this
before. Any tips to removing that cable - without damaging the
Ethernet port - would be greatfully welcomed.

patiwat_at_sloan.mit.edu

 >> Stay informed about: CAT-5 cable stuck in ethernet port - can't remove 
Back to top
Login to vote
Sjaakie

External


Since: Apr 26, 2006
Posts: 1



(Msg. 2) Posted: Wed Apr 26, 2006 6:55 am
Post subject: Re: CAT-5 cable stuck in ethernet port - can't remove [Login to view extended thread Info.]
Archived from groups: per prev. post (more info?)

patiwatp.DeleteThis@gmail.com schreef:
> I just bought a brand-new laptop (Thinpad R52) and connected a CAT-5
> cable into the Ethernet port. It seemed a bit tight at first when
> inserting the cable, but after a bit of pressure, I felt the cable snap
> in to place. Everything worked fine until I tried to remove the cable.
> Pressing down on the clip of the RJ45 connector results in a very
> quiet snapping sound, but the cable is still stuck hard in place.
>
> I've tried multiple angles, nudging it in deeper and then trying to
> remove it, pressing down both soft and hard on the clip, but the cable
> is still stuck in the port. This problem is pretty frustrating - in
> years of using networking gear I've never seen a cable stuck like this
> before. Any tips to removing that cable - without damaging the
> Ethernet port - would be greatfully welcomed.
>
> patiwat_at_sloan.mit.edu
>

You could try to use a small screwdriver (like they use for repairing
watches). Stick it where the clip used to be and put some light presure
on it (make the tip tilt slightly upwards) while gently pulling the RJ-45.

Good luck

 >> Stay informed about: CAT-5 cable stuck in ethernet port - can't remove 
Back to top
Login to vote
Travis M.

External


Since: Apr 27, 2006
Posts: 1



(Msg. 3) Posted: Thu Apr 27, 2006 1:55 pm
Post subject: Re: CAT-5 cable stuck in ethernet port - can't remove [Login to view extended thread Info.]
Archived from groups: per prev. post (more info?)

<patiwatp.RemoveThis@gmail.com> wrote in message
news:1146044508.437807.156740@u72g2000cwu.googlegroups.com
> I just bought a brand-new laptop (Thinpad R52) and connected a
> CAT-5
> cable into the Ethernet port. It seemed a bit tight at first
> when
> inserting the cable, but after a bit of pressure, I felt the
> cable
> snap in to place. Everything worked fine until I tried to
> remove
> the cable. Pressing down on the clip of the RJ45 connector
> results
> in a very quiet snapping sound, but the cable is still stuck
> hard
> in place.
>
> I've tried multiple angles, nudging it in deeper and then
> trying to
> remove it, pressing down both soft and hard on the clip, but
> the
> cable is still stuck in the port. This problem is pretty
> frustrating - in years of using networking gear I've never seen
> a
> cable stuck like this before. Any tips to removing that
> cable -
> without damaging the Ethernet port - would be greatfully
> welcomed.
>
> patiwat_at_sloan.mit.edu

If you just purchased it the warranty should still apply. Take
it back to the seller.

--


Travis in Shoreline Washington
 >> Stay informed about: CAT-5 cable stuck in ethernet port - can't remove 
Back to top
Login to vote
jacobyd

External


Since: May 02, 2006
Posts: 1



(Msg. 4) Posted: Tue May 02, 2006 9:23 am
Post subject: Re: CAT-5 cable stuck in ethernet port - can't remove [Login to view extended thread Info.]
Archived from groups: per prev. post (more info?)

Did you try needle-nose pliers to squeeze the clip and grab the connector at
the same time?


"Travis M." <Travis.Shoreline RemoveThis @gmen.invalid> wrote in message
news:Tr64g.1355$Te.1253@trndny04...
> <patiwatp RemoveThis @gmail.com> wrote in message
> news:1146044508.437807.156740@u72g2000cwu.googlegroups.com
>> I just bought a brand-new laptop (Thinpad R52) and connected a CAT-5
>> cable into the Ethernet port. It seemed a bit tight at first when
>> inserting the cable, but after a bit of pressure, I felt the cable
>> snap in to place. Everything worked fine until I tried to remove
>> the cable. Pressing down on the clip of the RJ45 connector results
>> in a very quiet snapping sound, but the cable is still stuck hard
>> in place.
>>
>> I've tried multiple angles, nudging it in deeper and then trying to
>> remove it, pressing down both soft and hard on the clip, but the
>> cable is still stuck in the port. This problem is pretty
>> frustrating - in years of using networking gear I've never seen a
>> cable stuck like this before. Any tips to removing that cable -
>> without damaging the Ethernet port - would be greatfully welcomed.
>>
>> patiwat_at_sloan.mit.edu
>
> If you just purchased it the warranty should still apply. Take it back to
> the seller.
>
> --
>
>
> Travis in Shoreline Washington
 >> Stay informed about: CAT-5 cable stuck in ethernet port - can't remove 
Back to top
Login to vote
Pete

External


Since: Sep 06, 2006
Posts: 1



(Msg. 5) Posted: Wed Sep 06, 2006 12:15 am
Post subject: Re: CAT-5 cable stuck in ethernet port - can't remove [Login to view extended thread Info.]
Archived from groups: per prev. post (more info?)

<patiwatp.RemoveThis@gmail.com> wrote in message
news:1146044508.437807.156740@u72g2000cwu.googlegroups.com...
>
> I just bought a brand-new laptop (Thinpad R52) and connected a CAT-5
> cable into the Ethernet port. It seemed a bit tight at first when
> inserting the cable, but after a bit of pressure, I felt the cable snap
> in to place. Everything worked fine until I tried to remove the cable.
> Pressing down on the clip of the RJ45 connector results in a very
> quiet snapping sound, but the cable is still stuck hard in place.
>
> I've tried multiple angles, nudging it in deeper and then trying to
> remove it, pressing down both soft and hard on the clip, but the cable
> is still stuck in the port. This problem is pretty frustrating - in
> years of using networking gear I've never seen a cable stuck like this
> before. Any tips to removing that cable - without damaging the
> Ethernet port - would be greatfully welcomed.
>
> patiwat_at_sloan.mit.edu
>

You're at MIT: take it over to the IT department and have them get the thing
out.
 >> Stay informed about: CAT-5 cable stuck in ethernet port - can't remove 
Back to top
Login to vote
Display posts from previous:   
   Hardware Problem Solving Community! (Home) -> PC Networking All times are: Pacific Time (US & Canada) (change)
Page 1 of 1

 
You can post new topics in this forum
You can reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



[ Contact us | Terms of Service/Privacy Policy ]