Jumper settings for CPU upgrade to 1.4

I recently did a bios flash on my Gigabyte GA6-BXC motherboard from
esuppot.com. All went well. But when I installed the POWERLEAP
PL-IP3/T PL-IP3T with a PIII-S 1.4GHZ processor it deaulted to 100mhz
10X speed giving me a processor speed of 1.05 rather than 1.4. Is
there a way to set the SW1 and/or SW2 jumpers on motherboard to
support a 133 bus speed that is necessary to get the new processor to
run at 1.4? My previous processor was a slot 1 Pentrium 3 850.

Thanks,

Bob

In message <81ckl39230af49gge9gubpuqkbpgbdufbm RemoveThis @4ax.com>, J Golden
<prettygoldenboy RemoveThis @yahoo.com> writes
>I recently did a bios flash on my Gigabyte GA6-BXC motherboard from
>esuppot.com. All went well. But when I installed the POWERLEAP
>PL-IP3/T PL-IP3T with a PIII-S 1.4GHZ processor it deaulted to 100mhz
>10X speed giving me a processor speed of 1.05 rather than 1.4. Is
>there a way to set the SW1 and/or SW2 jumpers on motherboard to
>support a 133 bus speed that is necessary to get the new processor to
>run at 1.4? My previous processor was a slot 1 Pentrium 3 850.
>
>Thanks,
>
>Bob
As far as I know the Intel 440BX chipset based boards only ever
supported 66 & 100Mhz FSB.


--
Peter R Cook