Monitor suddenly dead

I have been using a Neovo F-419 for almost 2 year without any
issue.

This morning, without any warning, the monitor failed to wake up
from sleep, is stayed dark. Actually, when I woke up my
computer's monitors, I saw a flash of the correct display
content, then the monitor went dark again. I tried several
things and eventually trying it without connected to the
computer at all (Neovo will display an error box in that case),
but it it consistently flashing up for a moment then going dark.
Seems like the backlight failed to start.

So my question:

1. Is there anything can be done with this monitor? If it can be
repaired, any suggestion where?

2. Any advice on what causing this? Any suggestion on what
should I do to prevent this happening again in the future? The
monitor do connect through a surge protector - albeit an old
one. As far as I know there is no electric discontinuity last
night: all electronic with clocks stays on, and the computer -
which stays on overnight and connected to the same surge
protector - still OK.

Thanks!

--
(stephan paul) Arif Sahari Wibowo
_____ _____ _____ _____
/____ /____/ /____/ /____
_____/ / / / _____/ http://www.arifsaha.com/

On Dec 8, 11:59 pm, S P Arif Sahari Wibowo <arifs....DeleteThis@yahoo.com> wrote:
> I have been using a Neovo F-419 for almost 2 year without any
> issue.
> This morning, without any warning, the monitor failed to wake up
> from sleep, is stayed dark. Actually, when I woke up my
> computer's monitors, I saw a flash of the correct display
> content, then the monitor went dark again. ...
> 2. Any advice on what causing this? Any suggestion on what
> should I do to prevent this happening again in the future?

Repairing it would cost more than the monitor. Why did failure
happen? Best evidence is the dead body - the reason to have it
repaired. Unfortunately, many repairmen don't have electrical
knowledge - only repair by swapping parts. That would defeat the
purpose of getting it fixed - to learn why this failure happened.

A most common reason for failure is manufacturing defect. Which
part has failed? Only then can we begin to ask why. Others instead
too often quickly blame heat or surges - blame only what they
understand. Rarely. Most likely reason for failure would be a
manufacturing defect in some component. Maybe a $1 part that costs
$100 to identify as defective. And that assumes one has the
schematics.