trudy wrote:
> Hi John
> Of course I have tried some research, I have looked for a schematic too
> no avail.
There is something called "google groups". You might look there before you
ask a question.
> If I new what too do I would be advising others and not asking others.
> I was unware that this was a common question.
If you had made even the slightest attempt to research it then you would
have found out that it was.
> I am proficient in the use of solder and multimeters, if I had
> followable instructions I am quite confident I have the abilty.
This is not a matter of "buy an XYZ chip and solder it into place"--you have
to figure out the interface on your LCD, identify a configuration of chips,
discrete logic, and analog components that will take the signal from your
processor into the LCD, obtain all the necessary components (this may be a
matter of cannibalizing other hardware or convincing a hardware
manufacturer to send you engineering samples, which they tend to be
reluctant to do), design a board to hold that circuitry with due regard for
stability at the frequencies involved, make the board, put the components
on it, put it in place, and test it. Invariably the first time you test
such a device something expensive makes a sound something like "drick" and
the smoke comes out and it never works again. In your case it would most
likely be the LCD that you are struggling so hard to salvage.
Now if you knew how to do all that then you'd be doing it instead of asking
for advice on USENET.
--
--John
to email, dial "usenet" and validate
(was jclarke at eye bee em dot net)
>> Stay informed about: laptop tft monitor use with desktop ? 
FAQ
Profile
Private Messages
Log in
